need help identifing a z-bar

[troy.70R/T]

Is this Z-bar for a B-body big block? it is 9.00 OAL and about 1-1/8 between the two legs. There are two numbers stamped on it. S359    and I think 32A. Thanks

[BIGBLCK11]

Mine has an S346 and 32K on it.  OAL 9", O.D. 1 1/4, 6 1/2" between the inside of the 2 legs.  I believe it was from a 69 Road Runner. I have an eleven inch flywheel or I would check the teeth for your other post.  

[troy.70R/T]

Thanks for your help I did some reaserch and since I am running an 11.00 bellhousing as well I need the on like you have that is 1-1/4 in from the end. Mine is only 3/4 in from the end. Thanks now I can post this in the trading section.

[BIGBLCK11]

The O.D. was outside diameter, mine is like 3/4 from the end also.  It should be correct for an 11" bellhousing.  That is what I have too.  The flywheel and Z-bar were out of the same car with a 11" bell, it had a thread issue and was pricey so I bought another separate.  What measurement did you mean for " 1-1/8 between the legs?

EDIT:  Ok, mine is just over 1-1/4 from the edge on the leg with a bend.  It is also what Brewers lists as correct for an 11" bellhousing.

[troy.70R/T]

yep thats the one I need. Thanks for the help. I have it posted in the swap meet trade section.