Front window interior trim question

[NGC414]

I just installed my headliner and cannot figure out how the upper front window interior metal trim piece goes on. Does anyone have a pic? I appears to screw on with several holes, but I can't find any holes in the car to mount to.

[Long Island RT]

There are clips that pop into the metal framing from the front just above the teeth that hold the headliner in.  They  go into small square holes.  Keep searching here, you,ll find a pic - I think there are 5 of them.

[Long Island RT]

Here try this:

http://www.dodgecharger.com/forum/index.php/topic,55956.0.html

It was in the interior section

[NGC414]

Thats exactly what I needed. Thanks for the help.

[Patronus]

Long Island RT, would you have more pics of your car? Are those Bassetts?

[twodko]

Long Island RT,
As it happens I am missing one clip myself. I have a spare one but these clips have to be installed when the windshield is out of the car.............yes??? If I can install this with the WS in place I can put in the last screw. Anyone?

[Long Island RT]

Long Island RT, would you have more pics of your car? Are those Bassetts?

They are Crager V-5's - real cheap too...

Long Island RT,
As it happens I am missing one clip myself. I have a spare one but these clips have to be installed when the windshield is out of the car.............yes??? If I can install this with the WS in place I can put in the last screw. Anyone?

I think you can put them on with the windshield in place - it's just not easy.  The clip needs to be squeezed with a needle nose to get it to pop back in the square hole.  It might be hard to find the square hole - use the trim piece as a guide for the hole location.

Good Luck.

[Patronus]

Thanks for the pic! I have something that looks very much like that.
The headliner trim mounting holes are only square on the outside corners, the middle ones have round holes (x4)

[twodko]

Thanks guys.