What do I do with this?

[terrible one]

I can't quite figure out what is going on here. From my understanding, the wire coming down from the dash harness plugs into the door jamb switch. That would work fine but I don't know what to do with the longer wire on the bottom. It has the same connector on the end of it as the one from the dash harness and seems to come up with the rest of the console wiring harness. The dash harness is a new M&H but the console wiring came with the car. Anyone have any ideas?

[Topher]

What does the schematic show?

[Nacho-RT74]

I think it should be, map light signal and or courtesy lights... but then, you should get female somewhere

[tan top]

I think it should be, map light signal and or courtesy lights... but then, you should get female somewhere

 

pretty sure that long male bullet conector goes to the door pin switch for the courtesy lights ,  there are miles of the yellow wiring back there especaily if has an A01 package

[terrible one]

Hmm so in that case I'm guessing the black thing on the long piece is a broken off female connector that the one from the dash harness is supposed to plug into, then the male bullet on the long one connects to jamb switch like you guys said

No A01 I'm pretty sure . . . Doesn't have a map light. Must just be console and dome light

Thanks guys

[Nacho-RT74]

Hmm so in that case I'm guessing the black thing on the long piece is a broken off female connector that the one from the dash harness is supposed to plug into, then the male bullet on the long one connects to jamb switch like you guys said

yes, pretty much must be in that way

one to dome light and rest of door ground circuit and the other one to console cortesy lights