Finally!! Pictures of my new R/T SE

[66FBCharger]

I finally found some time to go out and snap a few photos of my new R/T SE. I bought the car from an ad here on dodgecharger.com from a member. The car came from Wisc. It came with an extra pair of doors, a rustfree driver's floor assembly, a grille, the 4 speed pedals and gauge cluster and probably a few other items I forgot about. The fenders are clean rust free fenders. The floor has two 1/2 dollar size holes where you would put your feet if you were sitting in the drivers rear seat. The floors and frame rails look solid. The roof has surface rust but no rot. The front and rear window openings are solid with no holes. The 1/4s,trunk floor and rockers need to be replaced. I am sure I will find other areas that will need attention once I spend more time crawling all over the car.
All the body numbers match the VIN and the fender tag. The engine and trans. are missing. The Dana in the car is not the original. It is supposed to be a 4.10 out of a '70 Charger. It should be a 3.54 Dana in the car.

[Brock Samson]

 Looks like a mighty fine base for a Project...  Awaiting your plans and Pics. 

[billssuperbird]

 

[tan top]

Looks like a mighty fine base for a Project...   Awaiting your plans and Pics.  

 


nice set of slots      mmmmm slots 

[ChargerSG]

  Looks like a great project.

[aone415]

Very nice bones for a project! 

[Daytona R/T SE]

I want the wheels 

[Brock Samson]

 I allways hear about how guys like the slots and all,.. Mine are 14" deep dish, and I'd say a bit too small for a B-bod. Better on an A-bod. but i don't even know if they made '15s...  My Charger rolls a lot better on the 15s then it did on 14s, though the actual wheel+Tire diam. seems to be the bottom line rather then simply the Wheel Circumference.

[vancamp]

cool looking project.

[Lennard]

but i don't even know if they made '15s... 

Yes they did, i have a set 8,5x15 and 10x15 in my shed.

On topic, nice project Charger to fix up.