progress it's running!

[hotrod98]

I can e-mail you a few pics and a few tips on how to do it.
Most of them are on here somewhere. pm me you e-mail address.

[randr]

PM sent. thankyou!

[randr]

can anyone confirm measurement to mount scoop to fender? i got 29" from front of fender to front hole in scoop sound right?

[DAY CLONA]

Jason,.....measure from the back edge of the hood, along the fender to 16 inches +/- 1/4" to the rear base of the scoop,....the scoop sits centered on the fender with approx 1/8" on each side of the scoop, remember there is a drivers side and passenger side scoop

Mike

[randr]

Thanks mike

[randr]

I have search all places i know of, does anyone know vender or someone on this board  thats sells a package deal(hardware) to attach headlight doors, nosecone, valance, etc, etc... complete kit to install everything? or am i a dreamer?

[nascarxx29]

Dave Patik at PCG should have alot of that hardware
http://www.performancecargraphics.com/Winged_Car_Stuff/Hardware.htm

[randr]

Need some help again... i see pictures of daytonas that have this same problem! Anyone know how i can make top of fender match top of cone? both sides are same!

[Charger-Bodie]

Most of that is in how you have the front of the fenders adjusted.

[randr]

I have tried lowering outside edge but it's all the way. Do you have a picture of your daytona at same angle so I can see top fender position?

[Charger-Bodie]

http://www.dodgecharger.com/forum/index.php/topic,59899.575.html

There are other in my thread too , but that link should show you some. My nose is steel though,So I was able to manipulate thing to achieve the fit that it has.

This video link of my headlights opening shows it pretty well too.  http://www.youtube.com/watch?v=mmwDwSsk_2s

[randr]

So it looks like ousted top edge of fender IS lower than inside top edge?!

[Charger-Bodie]

So it looks like ousted top edge of fender IS lower than inside top edge?!

It actually ends up about leval.

[hotrod98]

I'm assuming that you have a fiberglass nose here. How the nose has been sitting over a period of time can affect the shape. A fiberglass nose should always be stored with the nose pointing up.
It looks like the nose is sagging since the fender has very little adjustment. Can you lift up on the ends of the nose and bring it in to alignment? If the nose is just thin and weak you may have to fab a support inside the nose. I've owned several noses and they all vary in thickness and strength. The Superbird nose that Montana bird just bought from me is a Dayclona nose and it is very, very sturdy.
If I lived closer i could help more.

[randr]

Ok. I got it alot closer by having friends wife sit on fender! Lol! It's a Janek nose and is very sturdy. Will post a pick when I get back to computer. On phone now. Thanks for the tips!

[BigBlockSam]

good luck man. that friggen nose fought us every step of the way 

[randr]

Well here is fit after a couple hours of tugging and pulling...

[Charger-Bodie]

Well here is fit after a couple hours of tugging and pulling...

Much better!

[BigBlockSam]

 

[tan top]

looks good     

[moparstuart]

 

[randr]

some more... need to fine tune headlight doors but otherwise done! NOT EASY! thanks for all the help guys!!

[BigBlockSam]

looks great . just like it should . i'd like to see your lights operate . can you post a vid. thanks

[randr]

another

[randr]

last for today