Anyone know what this is, and where it goes?

[Ex President]

Rolled the window down on the Charger (69) last week and it never came back up.

Pulled the door panel today and I find these two pieces laying in the bottom of the door.... I don't think I'll have any problem fixing her, if I just know where to put them. 




Any help would be appreciated!

[Ex President]

Ok... I figured out what the larger, "track looking" piece is and where it goes.

Looks like the little plastic button that held it in broke off.... I'm sure I can find something to replace that with. 

[tan top]

bottom picture ! is from the door vent window frame/post !! looks like the spot welds have pulled through !!  all with mine is clamp it in place & mig up either side 

picture is not chager ! all roughly the same    but this shows where it goes !!

[Ex President]

Much appreciated.... I actually ended up just drilling the spot welds out and putting a rivet in it. 

Looks like the only thing I need is the large plastic push pin thingee that holds the glass to the piece in the first picture.

Anyone have an idea where one of those could be attained? 

[69bfan]

The glass rivets may be possibly obtained from your body and paint supplier or glass shop.  Most of the larger restoration suppliers carry them.  If you are unable to obtain one locally, I carry them for your car.

[Shakey]

Much appreciated.... I actually ended up just drilling the spot welds out and putting a rivet in it. 

Looks like the only thing I need is the large plastic push pin thingee that holds the glass to the piece in the first picture.

Anyone have an idea where one of those could be attained? 

I can't recall where I purchased mine, either RT Specialties or Restoration Specialties - both in PA.

I may have noted it in my Interior Assembly Thread.

[Belgium R/T -68]

I bought mine on ebay.

Per