Engine parts list so far... Any changes?

[redmist]

Just getting togeather parts for my 440 build...

Use will be hot street,  (ANGRY!! RARRHHH!!))  and I may hammer it down the track a couple times a year..

Starting with a virgin 1967 non HP block 
Stock forged crank Turned .010
Stock LY rods turned .010

Machine work will be:

Cleaned
Fluxed
Align bored
Surface to zero deck
Recondition rods
Rebore with deckplate
Hone
Balance entire assembly

Bore is .030 over

Pistons are SRP Forged flat top with a compression height of 2.062
1.094 pins
Sealed power Plasma Moly rings
Clevite 77 P series bearings throughout
Rods stock LY With ARP Bolts
ARP main studs
Milodon 7qt pan  (already had it)
Windage tray
Edelbrock or 440 source heads 84cc chamber (have not decided on wich one yet)
Comp gold race rockers 1.5 ratio  (already had them)
Cloys True roller double 3 bolt timing (already had it)
TCI Rattler!!!  (OMG Becky!!)  Dampener (already had it)

Not sure on Intake

Not sure on CAmshaft

3.55 rear gear and about 3000 stall...     My goal is 500 HP..  Any ideas on a camshaft and an intake? I was thinking about the RPM intake, and I have been out of the loop on cams for so long I have no idea!! Most likely a Solid of some sort as I like playing with stuff..

[firefighter3931]

Here's a good 500+hp build using an off the shelf Comp solid lifter grind ;

http://www.dodgecharger.com/forum/index.php/topic,6000.0.html



Ron

[redmist]

Ahhh  That cam looks to be about perfect!!

Added to list...

Man this is fun!