Removing ignition Lock cylinder from a 70

[200MPH]

How do you remove the ignition lock cylinder on 70 charger ??

[b5blue]

Pull the wheel, loosen column support and wire cover so you can pull up turn signal switch and get it out of the way, remove 3 screws to first casting (that holds upper bearing) , remove pin from lock disk and remove lock disk. Now disengage keylock by inserting a small screwdriver in the hole at the center most part of the casting that holds the keylock assembly and pull lock out the side. Keep track of everything and remove anything I didn't mention that's in your way. 

[Nacho-RT74]

http://www.moparmusclemagazine.com/howto/mopp_0308_mopar_steering_column_rebuild/photo_07.html

[200MPH]

Thanks guys !

[b5blue]

Good luck!