Headlight Vacuum Harness HELP!!

[bill440rt]

I need a little help here, gang. I was installing my new repro headlamp harness to the back of the headlamp switch on my '69, that rectangular rubber connector with the 3 vacuum hoses that gets plugged into the switch. Well, I had to remove it again to re-route some other wires, and the vacuum hoses pulled right out of the connector! Dang repros!  

I want to glue them back in again, but I don't remember which order the colors go. The hoses are yellow, green, and plain. Looking at this picture, it appears yellow is on one end:

http://cgi.ebay.com/ebaymotors/OEM-correct-Head-light-vacuum-harness-1968-69-Charger_W0QQitemZ250036998691QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?hash=item3a375dd223

What is the order that these hoses should be in? I did a search on here & checked the FSM, can't find the answer.
Help!
Thanks!!  

[tan top]

  amber stripe  goes to the top of the headlamp door actuator , plain /no stripe goes to the bottom of the actuator ! the green stripe goes to the vacume canister  

here is the color codes to the head lamp switch  

[bill440rt]

That's EXACTLY what I need!
Dude, THANK YOU!!   

[gtx6970]

Bill,
My apologies , I completely forgot about this, until I ck'd messages then seen this thread.

[bill440rt]

Bill,
My apologies , I completely forgot about this, until I ck'd messages then seen this thread.

NO need to apologize, Bill!! That picture is perfect, too!
Thank you!!