Need an inner wheel house picture

[runningman]

Anyone have a good shot of this area?  I am not sure what the flange area that welds to the outer wheel house is supposed to look like. Thanks!

Matt

[hemi-hampton]

I could probably go out into my garage & take a Pic of my Chargers if need be? I had a Pic of that area but on my old Computer. LEON.

[hemi-hampton]

Took these just for you runningman. Hope these help. I noticed a slight cut or gap at very bottom that I did not notice on any others I've replaced in past. LEON.

[hemi-hampton]

Another Pic, Note the factory inspection marks on jack handle & ECS in previous pics. LEON.

[runningman]

Leon, thanks alot!  So it looks like the flange area cuts back at an angle when it reaches the trunk pan and extension.  What is that tube coming down on the passenger side?

Matt

[hemi-hampton]

Leon, thanks alot!  So it looks like the flange area cuts back at an angle when it reaches the trunk pan and extension.  What is that tube coming down on the passenger side?

Matt

Yes, Cuts back but I've never seen this cut back on the Sherman replacements & never noticed that before until now. Not sure if it's just a charger thing. Possibly this cut back on others cars if there was one would be sandwich between the 2 sheetmetal peices or below it & not visible because of this. That Tube on passenger side is the California emmisions or ECS (evaporative control system)

[runningman]

Hmm, I have never seen that before. 

[green69rt]

Here's my patch, I'm going thru the same thing as you.

[runningman]

Nice work!  Anyone have a pic of the wire holders that I am missing as well?

[hemi-hampton]

Here's some old Pics of my Buddy 70 Super Bee I restored. In the one Pic the wheel wells been replaced & the other original in Pic but got replaced. It appears to have a slant at bottom but I think these ended up not visable & below floor ? LEON.

[hemi-hampton]

Here it is Done. LEON.