Door alignment and gettin it to shut right

[AmadeusCharger500]

My door was hangin real low and always was hard to shut. Kinda bounced back slight open so it would rattle unless I really slammed it.
So I rebuilt the hinges, aligned it and it looks great but it still bumps to not quite shut position, unless I slam it!
So I tried adjusting the striker pin. And as I was doing so i took it off to examine it. Notice the remains of what was once a rubber bushing inside. Could this cause the door to not like closing securely?

[restoman]

Yes. The bushing needs to be there to take up the slack when the latch closes over it.

[1st_charger]

I am currently looking at a similar issue could some one post a picture of this?

Thanks

[AmadeusCharger500]

I'll try to get one tomorrow. Now where the heck does one get that bushing and whats it called?

[restoman]

I've never been able to locate just the bushings. Used strikers are what I've always used. I think someone - maybe Year One or The Paddock perhaps - offer new strikers, but if I recall, they were fairly pricey.

[Nacho-RT74]

I had to get the complete striker assembly too