Motor mount bolt?

[terrible one]

Does anyone know the size of the bolts that I need to secure the motor mounts to the engine and to the k-frame? And to the block? I need an answer ASAP as I'm putting my engine in today!

THANKS!

[mikepmcs]

J
Does this help

http://www.dodgecharger.com/forum/index.php/topic,13216.0.html

[mikepmcs]

getting closer, will these work. Size was listed in the ad.

http://cgi.ebay.com/ebaymotors/Mopar-Dodge-Plymouth-Motor-Mount-Replacement-Bolts_W0QQcmdZViewItemQQ_trkparmsZ72Q3a1171Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318Q7c301Q3a0Q7c293Q3a2Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem5d24ae836fQQitemZ400047375215QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

[terrible one]

Thanks man, that auction really helps.

I already got the hardware for Ron's motor mount fix, and did that as well so I'm pretty much sitting on go. Still, due to my lack of preparation and not getting the hardware way earlier, I couldn't find the sizes because none of the specialty fastener stores around here are open. Oh well, look for an engine in my car sometime in the upcoming week!

But one thing . . .

Are the bolts that go through the k-frame the same as the ones that go through the ears on the block?

Those are the last ones I need!

[mikepmcs]

I just went and looked at my 440 on my coronet(can't lift the hood on the charger, no hinges) and it appears the size is the same but length is obviously not. Each side had 3 nut/bolts  and only one long one going through the k frame.

I'll look for another auction.

[mikepmcs]

found this pic