Anyone elses BE/A hood turn signal boots do this??

[Just 6T9 CHGR]

Will do! 

[BROCK]

Heat shrink only shinks down to half it's original diameter

May as well go naked

[oldrock]

You can use some form of spacer to fill the gap so the sizes are closer to the same. I'd suggest using a piece of rubber or vinyl hose cut lenthwise that you can slip over the wires. That would add thickness so the shrink can properly tighten down... just a thought.

[TylerCharger69]

Aren't there supposed to be some sort of covers under the hood that conceal those?....

[1969chargerrtse]

If the second batch is proven to be better, Why not replace them again? Its not like its a 1000.00 dollar project.


PS My Charger has block off plates...they cause me zero problems!

Because thats where I'm at with my car....don't give a ratz ass anymore & am sick of doing things over again due to sub par stuff....wont give Mike or BE/A another dime of my $$$ as far as I'm concerned anyway.... I just wanna drive!!!

I hear ya brother.