e-head+msd ready to run distributor

[greenrt_se]

God damn..looks like MSD ready to run distributor don ´t fit on it ´s place whit E-head
so whitch msd distributor to buy in street RB whit al6 and blaster coil

[Chryco Psycho]

Eddy has been doing their homework again I see 
the Msd Pro Billet dist should clear

[CFMopar]

Did you consider grinding a bit of the head? You need only bout 1/8th i bet and the distributor looks almost full seated.

[morepower]

i hope my mallory unilite clears my heads..

[greenrt_se]

but how close the water passange is 

[CFMopar]

dont know maybe edelbroke knows

[greenrt_se]

whitout oilpump gear shaft ,the distributor goes where it have to,I maybe file just a little bit off the head side later today

[greenrt_se]

ok it ´s done 4 hours whit grinder,file and sand paper distributor goes in place,and there is room for one paper page between head and distributor

[CFMopar]

good job.  Better than buying a new distributor how much did you shave off? before and after pics plz

[greenrt_se]

first picture is from the head  ´hump ´have to grind it off almost all

the last is from distributor in place

[thallium]

Gosh, that is real tight.   I hope you do not have to advance the distributor any or you may run into more problems.   Looks like you got it cooked though. If it requires more mods to advance the distributor, you may just want to look for a mopar distributor. They fit without any problems.     Good job, looks nice!  BTW, you will like those e-heads.

[Mefirst]

I run the Pro Billet dist on my ride. It clears the heads, but I noticed that when I changed the Moroso valve covers to Mopar Performans, its a little tricky to get the passenger side cover off/on. The MP covers are made using much more material..