Emblem fasteners (i.e. bulge hood emblems, fender emblems.. etc.)

[RD]

Does anyone have any pics of these?  I bought a NOS pair of Ramcharger emblems off of greedbay and need to know what fasteners to use when I mount them on my hood.  thanks.

[Chryco Psycho]

I assume they have pins , so you need either the nylon or steel clip that slides over the pin & then the emblems just snap onto the hood

[Nacho-RT74]

nope... hood emblems and all those where are possible to get room when you isntall are selftaping nuts.

emblems where is not possible to get access to the back of panel, use the clips.

[RD]

you got a pic or part number for these snacho?

[AKcharger]

I just put a set on my '72, self tapping nuts that you can buy at auto zone. I'm down here near Nacho in Panama right now otherwise I'd snap a picture.

[Nacho-RT74]

no part number rignt now or pic... but you can buy a generic part on any car parts dealer. Is juts a 3/8" selftapping hex head nut.

WAIT I remember now... check your heater valve wire retainer nut at ac/heater control... is the same kind.