Marking of Edelbrock 60929 heads

[john108]

Do the edelbrock Performer RPM Chrysler 440 heads have the part number "60929" cast, embossed or stamped into/onto the head?
I am going to look at an unboxed "new" set tomorrow and would like to confirm that they are the correct heads.  Is there anything in particular that I should look for to satisfy myself that they are new and the correct model.  I would not like to get Chevy, Ford, etc.  heads by mistake.

[Runner]

i dont believe they have the part number cast into them.      will only have 3 e-heads for a bb mopar.  an open chamber rpm, and a closed chamber rpm and victors.  they are all easy to tell apart.  victors have the intake runner slightly cast into them.       i believe the only head that you might visually confuse with a bb mopar head would be small block chevy head.    the bb mopar head will be noticably bigger and have 6 valve cover bolt holes.   rocker shaft stands ext. if your familiar with a  bb mopar head,  they are easy to tell apart from any other head.

  this is a bb closed chamber mopar head   

[john108]

Thank you Runner!
Your discription and photo's were very helpfull. 
I matched the heads to your photos, exactly!!
The heads were still wrapped in plactic and it was obvious that they had never been touched.
I am happy as they cost a little bit more then the Stealth heads, and no shipping.

[Runner]

Thank you Runner!
Your discription and photo's were very helpfull. 
I matched the heads to your photos, exactly!!
The heads were still wrapped in plactic and it was obvious that they had never been touched.
I am happy as they cost a little bit more then the Stealth heads, and no shipping.

congrats on the good deal !!