Pics for Strat

[Shakey]

Stratocharger had requested a few photos of my exhaust tips after the install was all "finalized or tightened up".  I will also share them with whomever wants to look.

OK Strat, notice the clamp holding the tip to the tail pipe is now at 11 o'clock on the driver's side and on the passenger side it is at 1 o'clock.  I wasn't able to tighten them properly at 12 o'clock.

I also included a photo from the side, keep in mind the car is still on stands, as well as a photo of them lined up and level from the rear, despite the unlevel fuel tank.

Hopefully this will answer your questions.

Shakey

[AirborneSilva]

Looks good, thanks for the pics...

[cudaken]

 Good looking 69


                                   Cuda Ken

[Brock Samson]

 Thanks!    my trembeling MOPAR amigo! 
I expeced them to look a bit bigger, but maybe I can't really see it too good... the normal squared tipps look a hair bit small to my eye and I thought these might look 8-10% bigger,.. they look normal to me,. how 'bout you?.

commin' along BTW... 

[Shakey]

Thanks!     my trembeling MOPAR amigo!  
I expeced them to look a bit bigger, but maybe I can't really see it too good... the normal squared tipps look a hair bit small to my eye and I thought these might look 8-10% bigger,.. they look normal to me,. how 'bout you?.

commin' along BTW...  

Well, I don't know what to believe anymore     I have nothing to compare them to other than photos.  It seems there are a lot of reproduction tips out there and after asking the folks here about which ones were best, Accurate kept coming up.  I knew that there was going to be some modifications but I didn't car.  As far as size, I looked at some pictures I have swiped from the old site as well as the www and they all look so very close, as I said earlier   

I've looked at countless photos of cars, some restored some "so called" survivors and they all look so close I honestly can't tell!
Keep in mind Strat, the exhaust system from TTi is 2.5" OD (outside diameter) and the tips from Accurate are 2.5" ID (inside diameter), so they slip easily but snug, over the tail pipe.  If you have a 3" exhaust system, which I think you said you did, you could order 3" tips from Accurate and you will have to cut the end off of your system or you could order the 3" tips from TTi and they should slip right on and can be held with the clamp.