PIX, UPDAYTED DAYTONA PX , QTR PANEL INSTALL

[daytonalo]

HERES A FEW PIX OF MY HEMI DAYTONA [ RECEATION] AS BARRET JACKSON WOULD SAY . THE FOLLOWING PIX ARE OF 6 INCH HOLE CUT OUT UNDER FRONT FENDER WITH PLASMA CUTTER AND QTR INSTALL. THE TECHNIQUES THAT I CHOSE TO USE HAVE GIVEN ME THE BEST RESULTS OVER THE YEARS
CUT QTR OFF 1 INCH FROM JAMB AND 1 INCH FROM DOWN FROM UPPER BODY LINE
FLANGE THESE AREAS WITH AIR FLANGER
THIS IS A MUST , YOU MUST REBUILD DOOR HINGES AND FENDERS TO LINE UP ALL BODY LINES . VERY ,VERY,VERY IMPORTANT?
I TRIM QTR SKIN TO FIT IN FLANGED AREA AND USE 3/16 THICK WASHERS AND SHEET METAL SCREWS INSTALLED JUST ABOVE THE SKIN EVERY 4 INCHES SO THAT THE SKIN IS PULLED IN TIGHT TO GET PROPER WELD
TACK IN PLACE ON EACH SIDE OF WASHERS , THEN STITCH WELD IN SMALL INCREMENTS ON THE TOP EDGE ONLY . DO THIS WITH THE OUTER WHEELHOUSE IN PLACE WITH THE QTR SCREWED AND CLAMPED AT ROCKER
AFTER THE TOP EDGE IS WELDED UNCLAMP ROCKER AND REMOVE OUTER WHEELHOUSE, THIS WAY YOU CAN PULL A WIPE OF FILLER ON THE FLANGED EDGE THEN UNDER-COAT , THIS WAY YOU CANT TELL THERE WAS WORK DONE INSTALL WHEELHOUSE,PLUG WELD

[PocketThunder]

i cant see sh!t.     

[daytonalo]

TAKE IT EASY , CUPCAKE ! SORRY I'M HAVING A PROBLEM WITH CAMERA !

[THE CHARGER PUNK]

justa question what did your charger start life as?-MATT

[BigBlockSam]

TAKE IT EASY , CUPCAKE   

[sharpspike]

i cant see cupcake