Procomp Ready to Run Distributor

[jmanscharger]

Has anyone had any experience with these? Apparently connect the two wires to the coil and you are done? Isn't there something else?
I have one of these and don't want to fry something...

Procomps Ready to Run distributor is the perfect upgrade for outdated points distributors or bulky HEI's.
The Ready to Run features:

Adjustable mechanical advance which allows you to custom tailor an ignition curve to match your engine's needs.
A maintenance free magnetic pickup accurately triggers a high output internal ignition which easily out performs stock ignitions.
It will Smooth out the engines idle, improve starting and provide a much higher RPM range.
Improve stability and endurance, via an oversized steel shaft spins in a top mounted sealed ball bearing.
An extra long sintered bushing guides the shaft at the base of the housing.
There is also a vacuum advance canister to help improve economy.

All that is required is to install the distributor in the engine, connect two wires and you're Ready to Run.

[tecmopar]

I bought one for my '85 Gran Fury to get rid of that lean burn crap and so far, so good. NOW remember, you need a 12 Volt source, KO, for the distributor, don't use any ballast resistor wiring that drops voltage and in fact you can remove that as well. It almost cost me more for the plug wires then the distributor because of the HEI type cap but I needed them anyway. You can buy just the ends and boots to put on your plug wires if you have good ones, saves a lot of money, good luck.

[jmanscharger]

Ironically I blindly  bought a high dollar set of wires for $10 and then realized I couldn't use them with my stock set up. They were sitting on the shelf but now  I have a use for them. Thanks for the reply, I'll give it a shot.

[Savage6]

Hey guys, I just picked up one of these distributors, put it in and now my car wont start.  All it does is turn over and over.  I connected the red wire to the positive terminal on the coil and the black wire to the negative terminal.  I am using my original plug wires and Im not sure if that might be the problem or not.  The coil is a blaster 2, not sure if that is good enough either..  Any suggestions?   

[NorwayCharger]

Hey guys, I just picked up one of these distributors, put it in and now my car wont start.  All it does is turn over and over.  I connected the red wire to the positive terminal on the coil and the black wire to the negative terminal.  I am using my original plug wires and Im not sure if that might be the problem or not.  The coil is a blaster 2, not sure if that is good enough either..  Any suggestions?