carb jets from holley to demon

[greenrt_se]

Hi folks
can I put holley jets in the Demon carb? the motor running a rich side so I like to try 2 side smaller jets(carb is 750 demon mechanical secondaries)

[Chryco Psycho]

yes they will work .. I found that the sizes were about 4 off though .. can`t remember which way , we changed jets & made the problem worse , I think we replaced 76 Demon jets with 78 Holley jets & it became more lean so you will have to switch to the Holley jets & then figure out which way you need to go 

[Ghoste]

Does Demon publish a list anywhere showing jet diameters compared to their number?  If they do, you could just compare it to the Holley list to figure out which corresponds to which.

[Chryco Psycho]

not that I have seen

[Ghoste]

I suppose Barry Grant doesn't want to help Holley make a single cent after they forced him to change the appearance of his carbs.

[Chryco Psycho]

well he was kinda making Holley look bad too

[greenrt_se]

ok thanks guy`s .it is easy to see how A/F moving whit holley jets,cause I have a A/F ratio meter inside center console

[cudaken]

 Tomo, how much did the AF Metter run in US funds? Made in US or Finland.

                                  Cuda Ken

[greenrt_se]

here are link . http://www.fmi.vtoy.fi/

[cudaken]

 Timo

HALTECH, PC-säädettävät polttoaineruiskutus- ja sytytysjärjestelmät, niin kadulle kuin vaativaan racing-käyttöönkin 

Boy that was a big help, well I now know where it's made.

                                                         Cuda Ken

[greenrt_se]

ups..sorry ,the price is arouns 200 euros

[cudaken]

 And that is what in US dollar's if you happen to know? I have a ruff idea on Pounds to US but know idea on Euros.

                                Ken

[greenrt_se]

200euro=240usd

[Ghoste]

well he was kinda making Holley look bad too

They sure did jump on a lot of his ideas though.

[Chryco Psycho]

Yup