News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Brake pushrod

Started by terrible one, July 02, 2008, 10:17:52 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

terrible one

July 02, 2008, 10:17:52 AM

Okay, so I'm going with a manual front disc/rear drum setup on my car. I acquired a Master Power Brakes adjustable manual brake pushrod secondhand (not used though) so the little bushing on the end has already been installed, and we all know they brake upon removal. Therefore, I was wondering if anyone had measurements of an original manual brake pushrod so that I could just adjust the MPB one to that length and be good to go? Would that work? The MC is for a '74 Dart.

Chryco Psycho

#1
July 10, 2008, 01:16:35 AM
approx 6 1/2" overall length will be very close the problem is the length of the end inside the rear of the cylinder , ok I am back you lose 1/2 to the rear of the reatiner groove so about 6" from the rear of the seal that locks the rod in place

Just 6T9 CHGR

#2
July 10, 2008, 03:56:42 AM
:iagree:

Heres a shot of mine
Chris' '69 Charger R/T

y3chargerrt

#3
July 10, 2008, 05:57:25 AM
Chris, I hoped you cleaned that pushrod up before installing it... ;)

Just 6T9 CHGR

#5
July 15, 2008, 08:41:46 AM
Quote from: y3chargerrt on July 10, 2008, 05:57:25 AM
Chris, I hoped you cleaned that pushrod up before installing it... ;)

Nope....I installed this in its place.... :nana:
Chris' '69 Charger R/T

Print
Go Up Pages1
User actions