Little Help Please

[69hemi]

Looking for some posts or info on cradle dimensions for supporting the engine & K-Frame to lower the car over it for install. 

Please feel free to shuffle this post wherever you feel is best.

Many thanks for the forthcoming help guys!

[gers1968rt]

Here is the dolly i've made. It's made of 2x4 rect. tubing and a few casters I had laying around. I welded two bolts that line up with a couple of holes in the k member. I'll take some measurements the next time I go to work on it.  Gerry

[dodgecharger-fan]

John makes 'em

http://www.uscartool.com/kframestand/index.html

[70 Charger RT]

sweeeeeeeeeeeeeet hemi

[BROCK]

Most Excellent gers

[gers1968rt]

So, here is how I made this dolly. The cross T is 24 in. and the length is 45 in. I welded two half in. bolts 5 in. long on the cross T center to center 17 and 5/8 in. , these will line up with the holes in the k member. I haven't installed the engine yet, so if there are any mods that need to be done, I haven't found out yet. Gerry

[69hemi]

Outstanding Guys!

Thanks for the help!