Found that stupid electrical gremlin screwing with my ignition start up.

[70charginglizard]

Problems solved.

After pulling out the main electrical bhd connection from inside the car I found that the Blue/white ignitiion wire had rubbed thru one of the brown light harness wires causing my ignition problem.

All fixed now and working perfectly!

[myk]

Freaking bulkhead connectors...

[Nacho-RT74]

yeah, that was probably caused for you earlier fail, what made overheat the wire ... one fail gets to another and go on!!!

[70charginglizard]

Had to pull the bhd connector out again this weekend.
Turns out that the wonderful new splice connection I did on the dash side just before the bhd connection was a little too short. So it pulled it out a bit to much at the bhd connection and started doing the same crap again.
This time I bypassed the bulkhead connector completly! Ran the wire thru a drilled hole thru the connector and spiced it in on the engine side just after the bhd connector (where I can actually get to it easily if needbe from now on) Screw that damn bhd connection. I've had enough of that thing. 

[Nacho-RT74]

hahaha.

well. when electric is the deal, I check from end to end to be sure everything will play perfect as posible.