spot weld

[700jfm]

Best place to buy spotweld cutting kits snap-on wants $108.00 and I hear bad things about eastwood. What would be the best size to use for the trunk floor?

[Charger-Bodie]

 Try this : http://www.dodgecharger.com/forum/index.php/topic,24263.0.html  .....theres some good info in that thread!!

[700jfm]

Thanks I was wanting to use a grinder. I have a lot of them, I was worried about being retro correct

[Silver R/T]

this is good one. You don't go all the way through both layers of the metal
http://cgi.ebay.com/3-8-SPOT-WELD-CUTTER-FITS-MAC-MATCO-SNAP-ON-TOOLS-N-R_W0QQitemZ290185710101QQihZ019QQcategoryZ303QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

[700jfm]

Thanks I put in a bid. 

[hemi-hampton]

I'd use he Blair spot weld cutters, Disposable when worn out & just buy new bits. I bought the exspensive set up & said to Snap On HEY, what happens when they wear out, I gotta buy a whole new set, Strap on tells oh no, these last forever, Didn't last any longer then the Blairs, I got ripped.   LEON.

[700jfm]

I was going to buy sanp-on because that's what some one on here used. But when I saw what they wanted for it  I have no problem using a grinder and I will were I can. But I'm going to get the one SilverR/T suggested To use on any that a grinder might have a hard time with.

[bill440rt]

Go with the Blair's. 

I bought some from Eastwood at a swap meet thinking I could save a few bucks. Same principle, but complete junk. Worked like poopy.

[The70RT]

I bought some Blairs too. The ones from napa were just as good and were cheaper.