What are the correct motor mounts for a 70 440 b-body

[troy.70R/T]

I have a 70 charger with a 440. I know it has the right k-frame for the 440, However I have only about a half inch clearance between the original exhaust manifold and the shock tower on the passanger side. I ordered new motor mounts( just the rubber part) and took the steel part of the motor mounts off of a 383 motor that was in another 70 charger. My question is, are the steel parts of the motor mounts diffrent for a 383 and 440. could I have swithced them to the wrong side? Any pics or advice would be helpful. Thanks Troy

[GreenMachine]

Big block mounts for cars are the same, I stole these pics from Ebay.

[troy.70R/T]

Thanks for the pics. These look like the ones I have. Could you tell me from the picture witch one of the steel motor mounts mounts to witch side of the motor?

[Ghoste]

The one on the right in the photo goes on the drivers side of the engine block.

[oldkimmer]

And yes , the manifold can b that close as not all cars r created equal............kim.................

[raybeez]

Not to mess up this thread, but I didn't know where else to ask...

I have a broken motor mount in my 69 Charger. 383. Headers (if that matters...).

Where can I get motor mounts? The guy working on the car at the garage seemed to think they were a special order or something...but I got a pair for my Challenger on e bay.

Should I look on e bay, or NAPA?

Thanks

[GreenMachine]

You can get them at any parts store for under $20. Check out this link to keep from breaking them in the future.

  http://www.dodgecharger.com/forum/index.php/topic,13216.0.html

[Chryco Psycho]

Mancini sells Poly lock mounts that are design so they cannot pull apart