68 charger weight (update) Rate my Rack

[Lurker]

any idea what my stripped charger shell is gonna weigh? just wondering if the rubber tires i am using on my dolly will hold up 

[Mike DC]

       
Are they those rubber-tire-inflated caster wheels with the steel center, might be about 8-10" diameter? 
I've seen two of them put under the K-frame area holding up a Mopar unibody that didn't have a front clip or drivetrain.

[Lurker]

basicly ya, they have steel rims with little wannabe hubs bolted on, they are supposed to be good for 500lbs each. i will put the rubber ones under the front end and the end with the solid 3000lbs 8" swivel caster under the back.

i only need the dolly to move 10 feet out my garage door onto my gravel driveway so i can sandblast, eitherway k member is out as of 15 minutes ago and she is getting set on the dolly in the morning so i guess i will find out if they hold up or not lol

[Lurker]

done looks like my rubber tires are gonna work, just gotta remember to keep blocks under them incase i gat a flat while i am not home 

hows my "rack" look? is it up to standards?

[73ChargerSE]

Is it just me, or does that nose look like it curves upward? 

[70charger_boy]

Is it just me, or does that nose look like it curves upward? 

nah, it's not you

[Lurker]

it does look like a canoe in the pic, not sure why, but i measured all the gaps when it was on its wheels and about 700 other places and double checked everything before i tacked it down.

could just be that i shot the pic from close to the floor and the front lower fender is rolled in a bit. needless to say you got me worried now and its gonna get measured again lol

[73ChargerSE]

Sorry to worry you, but I guess it's better that someone said something.  I've always hated my eyes until now.

[Mike DC]

           
The car looks fine.  Optical illusion with the front valance hanging and the photo angle.


THIS  is a bent front end: