Hemi Head stud nut and bolt washers

[hemi68charger]

OK, another one.. I feel like a moron, but this is my first hemi..... Here are the washers that came with the bolt kit I have... What's the combination of washers to stud nut/bolt to these washer match to? The thinner washers have the modified design, not round...

Thanks again..
Troy

[hemi68charger]

Here are some more pics... There are 34 washers and 34 torque points.. I believe the thick ones go along the bottom 8 and the other 9 thin ones are on the rocker arm pedestals and nuts...   

Troy

[Hemidoug]

Troy,
The thin one's are for the studs. They are nipped so that they will sit flat on the studs inside the valve valley. You will not be able to get one of the thick ones to seat there if you try. You have too many of one and not enough of the other.

[Rolling_Thunder]

Troy - no worries - I'm currently building my first Hemi as well and facing alot of the same issues...     

[hemi68charger]

Troy,
The thin one's are for the studs. They are nipped so that they will sit flat on the studs inside the valve valley. You will not be able to get one of the thick ones to seat there if you try. You have too many of one and not enough of the other.

Doug, so the thick ones went on the 10 rocker arm pedestals as well? I see what you're talking about on the stud bolts.. Took me a good while to find the proper tool for the torquing of the stud nuts........ But, alas, Snap-On to the rescue...

Troy