Steering column ribbon cable

[RECHRGD]

I'm in the middile of installing a new dash harness on the '68.  I noticed that the insulation on the steering column ribbon cable assembly going to the connector in the dash harness is really looking and feeling pretty brittle.  Does anybody re-pop these?  I assume that connections up in the column are soldered.   Thanks, Bob

[Chryco Psycho]

the harness goes to the turn signal switch , you need to replace the whole switch to replace the harness , they are available new from Mopar & Year one but not cheap , $200 range if I remeber correctly

[RECHRGD]

Thanks Neil

[Just 6T9 CHGR]

Part # 2947801  1967-69 A, B-body vehicles still avail at your local dealer.....list around $90-100

[Chryco Psycho]

typical , 1/2 price south of the border
what you should know is the dealer TS switch is a repro and not as good as the original

[Just 6T9 CHGR]

NOS

http://cgi.ebay.com/ebaymotors/NOS-Mopar-1967-69-A-B-body-turn-signal-switch-2947801_W0QQcmdZViewItemQQcategoryZ50459QQitemZ7940445140QQrdZ1QQsspagenameZWD1V

[RECHRGD]

Thanks Chris & Neil.  I don't do e-bay but I'll check at my Dodge Dealer in town.  That picture dosen't look like a ribbon cable, just single conductors without the plug.  I guess being a replacement that the pins on the end will fit into the original plug.  Bob

[Chryco Psycho]

Yes , you need to map the positions of the connectors , slide the wires into the column & insert them into the plug