833 shifter linkage photo???

[Alain426]

hi, im in the process to restore my 833, but i made the mistake to dont take picture of the disassembly 

now, i need some help to get the linkage in the proper position

its a b body (charger 71)  with a console  (long rods)


i think i know that the 3 lever must be upside,  but i dont know how to positionate those lever, cause it has a small angle in the slut, so they point more at right or more at left

and how the rods goes, in tHe interior or the exterior

if someone have a picture of this kind of setup, thanks to post it here

thanks you  Alain

[mikepmcs]

I really think this site might help you out.

http://www.slantsix.org/articles/4-speeds/ODA833fourspeed1.htm

v/r
Mike

[Alain426]

yes thanks, i saw this picture yesterday, but on this picture, the rod on the 1-2 speed are in the interior, near the transmission, and on mine, i cannot put the rod between the lever and the transmission,that why i wanted some more information,  thanks again

Alain

[tecmopar]

Sounds like you have the levers mixed up, the 1-2 lever is off-set to allow the rod to go in from the inside. What are the #'s stamped on your levers.

[Alain426]

yes thanks you got it

the number on the lever are 366  367  368

and here is the solution

and dont take attention to the rod and the wire to retain them, the rod arent restored yet and the wire its temporary to test my rod

[tecmopar]

There you go, Glad I could help, good luck.