Daytona jacking instructions decal?

[Daytona R/T SE]

Can someone post a good pic of the Daytona scissor jack instruction decal on inside of the trunklid?

I'm trying to figure out which hole in the framerail to stick the scissor jack "post" into

[nascarxx29]

Try in here

http://wwnboa.org/daytdetails.htm

[daytonalo]

the post does not go thru the frame rail , its to the left of it . Can you please post a picture of your scissor jack , I need some ideas .

[nascarxx29]

The scissors jack which is only intended for front use.Should have locater holes on the B body unibody subframe.That that jack pin locks into.Is that what your asking about?

[Daytona R/T SE]

The scissors jack which is only intended for front use.Should have locater holes on the B body unibody subframe.That that jack pin locks into.Is that what your asking about?

Yes,the jack pin goes into one of these holes in the frame-the instruction decal shows which hole, but I can't remember which one it is. I've installed hemi torque boxes and the B-body convertible front frame reinforcements on my clone-the front reinforcements interfere slightly with one of the holes in the front frame rail-IF it's the one the jack goes into I want to make any necessary modifications BEFORE I take the car off the rotisserie in the next few weeks.

There are two possibilities- one of the holes is about 2" forward of the torsion bar cross member, the other is about 10" further forward than that.

[daytonalo]

are you going to use the jack in an emergency? Post some pics of your jack

[nascarxx29]

If I had a close up on the daytona jack instructions.It shows the jack placement location

[hemigeno]

RATS!!

I was hoping to dig through my pictures this morning of the decklid from my Daytona.  I was just sure I had a closeup of the sticker...

Unfortunately, this was the closest/most detailed pic I had, and it cut off the top half of the label.

Sorry Chris!

I also tried to do a search through the usual suspects' websites to see if someone had a graphic online, but to no avail.  It'll be two weeks before I get up to Michigan to check on my car, but the decklid will probably be all cleaned up.

[nascarxx29]

This might show where it is placed

[UFO]

here ya go

[Daytona R/T SE]

RATS!!

I was hoping to dig through my pictures this morning of the decklid from my Daytona.  I was just sure I had a closeup of the sticker...

Unfortunately, this was the closest/most detailed pic I had, and it cut off the top half of the label.

Sorry Chris!

I also tried to do a search through the usual suspects' websites to see if someone had a graphic online, but to no avail.  It'll be two weeks before I get up to Michigan to check on my car, but the decklid will probably be all cleaned up.

Thanks for trying, Geno!  I tried blowing up a few pictures I had (including a couple of your car )  but they were all at the wrong angle, too dark, etc. to read

[Daytona R/T SE]

This might show where it is placed

Thank you too XX29 for your help...still couldn't read it though...

[Daytona R/T SE]

here ya go

UFO!  THAT'S EXACTLY WHAT I NEEDED!!!  THANK YOU VERY MUCH!!!