Power window wiring hole location?

[Daytona R/T SE]

I need to know where the hole on the door jam goes for the PW wiring harness on a 69 Charger. I'm converting my car to power windows. I'm using the doors from a power window car, but I need to know the size and location of the hole were the harness leaves the body in the door jam area. There is a dimple in the metal about 3" (rough guess) below the lowest bolt hole of the upper door hinge-could this be the factory "marking" for this hole's location? Pics? Measurements? Please?

[Daytona R/T SE]

bump

[Charger-Bodie]

that indend is the mark where the hole goes as for the size i cant remember do you have the gromet tube that the wires run thru ,you could mease that but make sure not to make the hole too big the reason i say this is because my old charger had fact. pw and the tube grommet shrunk over the years and i was always puntting it bac in the hole ....im thinking the hole is the same size as the hole in the door but im not 100% sure so dont take it as gospel

[Daytona R/T SE]

I've got the grommet put away somewhere, but I wanted a measurement of the actual hole, since the grommet has probably shrunk over the years.  Maybe someone has a power window '69 torn down and can take some measurements?

[Mfr426]

Hey, I have a 69 SE with stock PW. You're looking for the jamb side of the wiring grommet? Perhaps I can help.

PM me...

Mike

[Moparbob]

Anyone know if the dimples are staggered on a 73? I have a dimple in the door below the top hinge and another further down on the door piller. Im about to drill the holes,,,, today 

[maxwellwedge]

I've got the grommet put away somewhere, but I wanted a measurement of the actual hole, since the grommet has probably shrunk over the years.  Maybe someone has a power window '69 torn down and can take some measurements?

If you haven't got it figured out yet I can take pics of my car for you.

[Moparbob]

I've got the grommet put away somewhere, but I wanted a measurement of the actual hole, since the grommet has probably shrunk over the years.  Maybe someone has a power window '69 torn down and can take some measurements?

If you haven't got it figured out yet I can take pics of my car for you.

PLEASE

[Moparbob]

I've got the grommet put away somewhere, but I wanted a measurement of the actual hole, since the grommet has probably shrunk over the years.  Maybe someone has a power window '69 torn down and can take some measurements?

If you haven't got it figured out yet I can take pics of my car for you.

Yes Please I need some pics

[Moparbob]

Max is going to send me some pics but his car is a 69, anyone have a 71-74 with power windows?

[Moparbob]

Help! Is there no one with a 73 charger that has power windows? 

[Moparbob]

Thought I would try one last time

[dongar69]

I know this is an old topic, but, I need some pics of hole location for power window harness through door and body.
Performing a power window install. Any help would be greatly appreciated