Wingcar part or not

[nascarxx29]

I had found another use this particular part on a 69 daytona nose build up.Insteed of what its suppose to be used for support the screen door cylinder.It does look like a little down sized wing upright though .It fits flush and hollow in the middle for the actuator shaft to travel.I had found on fiberglass headlight pivot bracket to actuator connection.Is a problem waiting to happen.I had used this before on a clone daytona.Where the fiberglass bracket on fiberglass headlight headlight pivot failed. .And got it in there without tearing down or removing a nose on a finished car.By removing the 2 headlights shortening the bracket and drilling a hole for acuator connection point .And I used that part again on a real daytona.Where I get ridiculed for doing so .When I worked and drove my cars .There was no message board or part suppliers as compared to any wing car part today being repoed.And when I bought these cars in states 1500- miles and up away .And in general when I have had whatever problem.I used what I had available.To make the fix and get going again.I guess that makes me old school .I did have these nos parts to make paper templates for nose cone assembling.When I needed to make them







  daytonalos statement
And the nose was hanging off to on side 1/2 inch , oh yea nice work ,  when I asked you whats up with that , your response was DA I DON'T KNOW ! your a butcher , always have been !!!!!!!!!!!!!!!! 

 Not in my job description to align a tweaked over inner fender wheel .That was old days brazed in place incorrectly.That required me to shim one of the channels

[69_500]

I really can't make heads or tails of this post.

What are the photo's of.

[nascarxx29]

The parts in black with white wriiten part numbers are nos daytona pieces.I made copies from .The other picture is a susbstitute part.I used on wing car nose builds

[nascarxx29]

The work results

[69_500]

Okay I get your drift now.

Interesting tid bits there Dave.