reset button wires, please 74 owners, is not hard to check

[Nacho-RT74]

Ok, since I removed underdash harness because I'm checking everything I'll install at the same time the interlock system, but has another doubt beside the undercarpet to seats/buckles harness.

Reset button I found was with pigtail, not with complete engine harness. On underdash harness I have one yellow wire that plugs as diagram states on reset button, and another yellow traced black that I know runs directly to starter relay. Diagram is very clear about that.

What doesn't say diagram is what wires plugs on what reset button terminal. That's not really a problem since I have the pigtail, that was the reason I did need the pigtail when I was searching HOWEVER...

Diagrams shows clearly same wires I have on underdash harness: yellow ( spliced from starter relay wire ) and yellow traced black arriving drectly to reset button BUT on pigtail with plug I DON'T HAVE ANY YELLOW TRACED BLACK, just two regulars yellows.

WHICH ONE PLUGS ON WHICH ONE ? I guess is the same which one you plugs at what prong, but I wnt to plugg it as originally is.

attached, diagram

[71_deputy]

Nacho- one wire is a 18 gauge wire and the other is a 14 guage- maybe you can figure that out via the diagram!!

John mac

[Nacho-RT74]

On pigtail both are 18, is just a 2 inches pigtail. I have to build the engine harness with that.

14 gauge is just behing of bulkhead. CE2 is the code for the bulkhead plug

[71_deputy]

YOU MAY HAVE TO TAKE THE ELECTRONIC box off the connector and ohm out the wires between the box and the connector.

[Nacho-RT74]

 

If I know how it exactly works, will be nice, but since I don't know, then...

[Nacho-RT74]

C'mon guys... I really need the car, is my daily driver and need to assembly again. I don't want assembly it twice once I get the answer

[Nacho-RT74]

THIS is what I need to know... MAYBE the exactly routing is not important and is not really important if they are turned around but JUST IN CASE, I would love to know how was assemblied from factory.

IF points 1 and 2 are identified with a tester by continuity, rest if piece of cake...

However, I hope I can get soon THIS exactly harness

[Nacho-RT74]

 

[Nacho-RT74]

 

[ScottW]

Let me start by saying that I don't really understand what your asking help on. But maybe this diagram will help.

[Nacho-RT74]

I was trying to know specifically which one of both yellow wires arriving to reset button, goes where on to engine harness, but even I still haven got the exact answer, with diagram you posted now I know HOW is wired the starter relay coming from ignition switch and interlock, and IT LOOKS the same stuff  how you plug the yellow wires on reset button.

will be great anyway to know exactly how exactly was wired from factory, but this diagram helps A LOT.