A litle Picture Help Please

[69hemi]

 Finally have to deliver the car and I can't figure it out.  Great, I can restoerehe car but can't figure out the spare.  Does anybody have a good shot of the spare tire hold down hardware all goes?

[Just 6T9 CHGR]

Jet, not sure what you're looking for......the spare tire stud is bolted to the bracket welded to the trunk floor.....

[69hemi]

My bracket does not have any hole with threads.  Is there a clip nut that goes there?

[Just 6T9 CHGR]

Jet, there are no threads....... its a hex head bolt with a nut....straight through

[hemigeno]

Here you go Jet - finally some help I can give you, rather than the other way around!

[Just 6T9 CHGR]

Beat me to it Geno

[hemigeno]

Beat me to it Geno

 

[lilwendal]

Guys since we're on this subject I'm curious if anyone knows which hold down nut is correct for 68?  I know I'm only doing a clone but I'm trying to get everything as right as possible.... Except the obvious plum paint.........does this just depend on what plant the car was build or is one 68 specific? Thanks

[69hemi]

Thanks for the help guys. 

[hemigeno]

Guys since we're on this subject I'm curious if anyone knows which hold down nut is correct for 68?  I know I'm only doing a clone but I'm trying to get everything as right as possible.... Except the obvious plum paint.........does this just depend on what plant the car was build or is one 68 specific? Thanks

The nut on the left is the style that is on my '69 Hamtramck car - I don't have a '68 to compare it too, and I haven't looked at my '69 St. Louis car to see if it is any different (sorry).

[MoparMotel]

This is a 69 setup.....What does a 68 set up look like?