racing harness

[Silver R/T]

how would I go about installing racing harness in 68 without drilling holes. Would be stock seat belt anchor holes enough to install racing harness?

[Silver R/T]

http://cgi.ebay.com/ebaymotors/2-New-Racing-Seat-Belt-4-point-Harness-sets-Black-belts_W0QQitemZ130005157081QQihZ003QQcategoryZ42612QQrdZ1QQcmdZViewItem

this one claims to work with stock mounting holes

[RallyeMike]

Most racing classes that require a harness, require them to have a 5 point system with 3" belts.

If a 2" 4-point belt is what you are looking for, I question how the shoulder straps bolt in without extra mounting points? Shoulder mouning is important, and running shoulder belts down to the floor behind the seat is not an allowable or good installation according to the most racing rules and all safety belt manufacturers.

[Reidar]

Hi Silver!

The way I did it when i put 4-points in my -68 was to take out the backseat and use the original holes for the backseat-belts for the shoulder-harnesses.
It's not an optimal sollution, but it passed the technical controll when i drove street-leagal dragracing.
Just make sure the shoulderstraps are long enough.


Reidar