FUEL TANK

[poppa]

Hey all , Maybe it was just wishful thinking but , I thought I remembered reading a number of years ago , someone cut open a tank for setting pick up height and sending unit (gauge) adjustment and rented it out ? Sound familiar to anyone? Thanks
69 Charger

[Kern Dog]

You don't need that.
Just take your sending unit and test fit it as is, then remove it and bend the inlet with the fuel sock about 1/2" down and trial fit it. Do this until the base plate will not sit flat against the tank, then bend the line up a little and test fit again. This costs you nothing and will allow you to get the inlet as close to the bottom of the tank as possible.

[will]

https://www.tanksinc.com/cartimages/prd_748.jpg?id=202002031608350

 It comes with instructions too!