will a body (duster) Dana 60 fit okay for b-body

[ACUDANUT]

will a body (duster) Dana 60 fit okay for b-body ??

[Alaskan_TA]

No Plymouth Duster ever originally came with a Dana 60.

[Kern Dog]

will a body (duster) Dana 60 fit okay for b-body ??

[ACUDANUT]

 I never said it was Factory.

[John_Kunkel]

The answer is "maybe", need more info like method of mounting and overall width. But a bolt-in? No.

[Kern Dog]

You are asking if an axle that someone took from another vehicle and stuffed into a Duster would fit a B body.
I'm sure that people here would love to help you but with no specifics, it is impossible to give you an accurate answer.
This axle in the Duster could be from a 1 ton Dually truck and stick out 8 inches past the body on each side. Sure, it fits but it isn't right. No, that wouldn't fit the B body any better than it did the Duster.
If the axle was cut down and narrowed, maybe your question should be : "Would a stock width axle from a Duster work in a B body"?
The "A body" axle widths are approximately 3" narrower than a 68-70 B body. I had a C body axle narrowed to "A" body width for my Charger but later swapped a 66-67 housing in because the "A" body width tucked the rear tires in too far. IF you're starting from scratch, it makes it easier to decide.

[b5blue]

No it will NOT fit. 

[John_Kunkel]

Could be one of these from the seventies, still a lot of them around.