Rear belt moulding fitment

[RTSE440]

Hey guys and girls I'm assembling my car at the moment i just finished the vinyl top and putting the rear belt moldings on the ones below the 1/4 rear windows shaped like a j how are these mounted I'm stumped

[Mike DC]

The pieces that make the inner halves of the vinyl top chrome trim?  Mounting holes drilled in the quarter panels.

[RTSE440]

Correct they are the ones the issue is the holes behind the screw holes are larger am i missing something

[RTSE440]

This is in it's proper position  so the large round holes are behind the small counter sunk holes on the molding

[tan top]

your missing the special jnut clip thingies , there are four each side , or should be  , mine only 3 each side  , & previously had never been appart , guess the assmebly line workers were looking  for any ways to cut corners & save time 

https://www.rtspecialties.net/proddetail.php?prod=6026552

[RTSE440]

Thank you all  Also while on the subject do the window sweeps go in now or after the window is fitted ?

[tan top]

been well over 20 years since i put mine back together & spent hours & hours  aligining  front & rear side glass to get it dialed in , i've posted at least in two threads  how to go about it all i  know  other members have done a few good info posts also , just had a look but cant find anything  
 you can put the whole window regulator in  then fit the glass  ,  make sure you use the rubber bushings  ie  cut lengths of over flow hose as per factory ( used as bushings / spacer things)  that go  round the bolts that hold the glass to the regulator . you  can then fit the belt moulding & catwisker rubber seals  , you might need to adjust the glass stops to alow the glass to be lowered to the max , or if you have taken it all to bits leave that loose  so you can lower class right the way down to allow   for access to the j bolt screws,  

[RTSE440]

thanks all