Daytona turn signal spacers

[BS27ROB]

Does anyone have the dimensions of the 3 different size spacer blocks that are used in mounting the turn signal housings to the z-brace brackets on a Daytona?

[nascarxx29]

Maybe someone repos them 3 aluminum blocks with a hole

[panhead]

Good day sir,

I received this information from hemigeno: 

>  Each spacer is constructed from solid aluminum, approximately 1/2" x 1/2" square

>  The top spacer thickness was 1/8"

>  The middle spacer thickness was 3/16"

>  The bottom spacer thickness was 3/8"

>  The screws were a 1/4" hex washer head, with slot

  Hope this helps.

Curt

[BS27ROB]

"Hope this helps.

Curt"

It certainly does, thanks.

Cy

[nascarxx29]

Pictures

[BS27ROB]

Thanks Dave.

[426HemiChick]

Pictures nascarxx29

Hi nascarxx29,                   25 October 2022

That's a nice looking Daytona Nose Cone. It's either a restored Creative Cone, a factory new or an Aftermarket. Sure looks nice from the photos. Could be a fourth option but can't think what that would be.

Best Always

426 Hemi Chicks

[nascarxx29]

Gene Lewis AKA Hemi Genos restoration thread .Restored by Vance Cummings Michigan

[nascarxx29]

http://www.dodgecharger.com/forum/index.php/topic,48725.0.html