DAYTONA-SUPERBIRD SCISSOR JACKS WITH HANDLE , 375.00 WITH HANDLE

[daytonalo]

3/8 dia ? Where the pins go through the coupler , are the ends of the rod flattened out and drilled or are the ends just left round ?

[hemigeno]

Where the pins go through the coupler , are the ends of the rod flattened out and drilled or are the ends just left round ?

This one I do know...  the ends of the rod are just left round.

[daytonalo]

Awesome , one more thing , what gauge metal is the coupler ? what dia are the rods ?Can you please give me the length of all bends . Thank you , Larry O

[nascarxx29]

I searched the web for scissor jack handles.But did see this.And it did happen to mention having acme fine threads .

http://www.norcoind.com/norco/mechanical.htm

[daytonalo]

Taking orders , 375 with new correct handles . Larry @609-315-2230

[nascarxx29]

Sounds like a decent package deal.Some of the ones I.ve seen claiming to be the real deal on ebay were bogus
.And you could maybe take this existing jack and taper the end shaft weld on top locator pin and cut out the feet and drill the hole for the cotter pin limiter and add the collar bearing.The other alternative is the daytonalo jack.Here what my original and a some other jack I came across looks like

[daytonalo]

The jack in you pic is not even close . How do I know this ? I ordered one , when it came in I said no thanks , its paper thin, and slightly smaller, no bearing . the top plate is not even on the same planet . LARRY

[nascarxx29]

Its all in the details.I had 2 previous jacks both red I had from sometime back.Had all the right details except for the top pin.This reference page shows the jack and handle from a documented low mileage original.  To make a comparision to this newly marketed one.
http://wwnboa.org/daytdetails.htm

[daytonalo]

I agree, I can make a jack with the correct thread pitch and correct rivits , only thing I would have to charge 800.00 with handle . Again the new jack is not even close to the orig jack , dimensionally smaller , no bearing , wrong top plate , side bars are thinner . I ordered one to compare , when it came in I said no thanks . Anyway this is the best I can do , maybe you can supply a 100% correct jack , it would take a load off me . Larry

[69_500]

Just had to do it.

$800 are you crazy.


Had to say it.

[daytonalo]

It's a ton of work for a dead nuts correct jack ! Didn't the last one sell for 1200 without handle on e-bay ? Sorry I cant work for free !!!! Larry

[nascarxx29]

Thats why the real ones command big dollars as they do .I sold one with no jack handle or hold down.For a hemi daytona that was at Roger Gibsons.$3K.Supply and demand such as the rear window trim that just sold for $6K

[69_500]

or the NOS nose cone that someone is asking $16K for. No one ever asked you to work for free, just making a point.

[Dga26]

Are these jacks still available Larry?

[daytonalo]

no , post was from 14 years ago . I do have only one jack left , no handle it was my personal jack and it isn't going to be cheap  Only making A-pillar trim , they are listed on ebay . I can do better on price contact me direct
six o nine  315-2640

[Sgt Superbird]

And I have a jack handle that is very close to an original one.

[odcics2]

And I have a bunch of "very close, some exact", need to modified with slotted bottoms and nub on top jacks! 

[WINGMAN]

  Anyone making the hold down bracket    Wingman    Jay.

[nascarxx29]

Try riksparts.net