68 valance corners ??

[Highbanked Hauler]

 in setting the ass end of my 68 I was lining up the AMD valance corners which have a "tail" on them. Where does the tail fit, does it go between the trunk floor extension and the quarter or does it weld to the bottom of the quarter ??  Thanks.

[armor64]

doing this part of the car has been the roughest for me, but i believe the tail at the bottom goes under/on the quarter panel bottom edge, i think bent forward (pointing towards the front of the car). i put it above the bottom lip, not sure if correct, but it looks better, and i haven't found great pics of the area to help me either.

[kent]

Check this out. It might help, it might not? Great video just the same. I like that young fella.


https://www.youtube.com/watch?v=Ln9P9MhRHME&t=2520s

[Highbanked Hauler]

doing this part of the car has been the roughest for me, but i believe the tail at the bottom goes under/on the quarter panel bottom edge, i think bent forward (pointing towards the front of the car). i put it above the bottom lip, not sure if correct, but it looks better, and i haven't found great pics of the area to help me either.

   I agree, I am adjusting a bunch of loose parts vise griped together and don't want to cut anything till I am sure that I need to. I am guessing that tail was needed when the pieces went into the jig for welding but I don't see a purpose for it .

  kent I have seen some of his videos especially "Daisy" and sheetmetal work that went into it.

[Magnumcharger]

Here is the corner cap/rear valance/quarter panel interface on an original 1970 Hemi Charger.