Master Cylinder Boot & Rubber Clip Needed

[CRW-FK5]

I need to replace the rubber clip and boot on my master cylinder push, rod but am not able to find replacements anywhere.  Does anyone know where I can locate these?

[Just 6T9 CHGR]

Boot....

http://www.megapartsusa.com/proddetail.asp?prod=102%2DBB1

[BLK 68 R/T]

Found this as well.

http://therammaninc.com/products/shop_list/Master-Cylinder-Hardware-443

[CRW-FK5]

Boot....

http://www.megapartsusa.com/proddetail.asp?prod=102%2DBB1

Thanks.

[CRW-FK5]

Found this as well.

http://therammaninc.com/products/shop_list/Master-Cylinder-Hardware-443

Thanks.

[A383Wing]

The rubber "clip" as you call it is just a piece of vacuum line cut to fit.....I used that on my master cylinders in the past...available at any auto parts store, and a lot less than $16

Bryan

[Canadian1968]

Is this not the boot that is on the brake BOOSTER and not the master cylinder ?

[A383Wing]

I don't think his car has a booster, it has manual brakes....otherwise he would not be asking for the rubber "clip" that holds the brake pedal rod into the back of the master cylinder piston

Bryan

[CRW-FK5]

I don't think his car has a booster, it has manual brakes....otherwise he would not be asking for the rubber "clip" that holds the brake pedal rod into the back of the master cylinder piston

Bryan

Correct.  Manual brakes.  I did hear about trying to size up a piece of rubber tubing and am going to try that approach.  I may even try and cut that groove in the outside like the original.  Thanks for posting your reply.

[A383Wing]

Correct.  Manual brakes.  I did hear about trying to size up a piece of rubber tubing and am going to try that approach.  I may even try and cut that groove in the outside like the original.  Thanks for posting your reply.

Nobody is going to see it anyway......

Bryan