Headlight doors connected correctly, but won´t move

[cvf]

Hi,

as Subject says...vaccuum lines are mounted correctly, switch top vac is yellow, then green, black. Green to canister, yellow to top of actuator, black to bottom.
Each of them splitted by a T connector.
Switch is really hard press. I can open doors by hand easily. When I switch the yellow and the black line going to their T-connectors, doors will open quick, but no lights on.
A member mentioned the same problem, but his was solved by disconnecting the T connector that was falsely before the canister at the green line.
Any ideas, oder someone who had the same problem?

Chris...

[Hard Charger]

"switch a hard press"  Guessing you have a 68?

could be the vacuum gate behind the dash switch.

[cvf]

Hi,

but how to remove that vacuum gate?
yes, its a 68...
Cheers, Chris...

[Hemidog]

The headlight switch can be disconnected from the vacuum gate.

If you want to rebuild it, it needs to be drilled open. I drilled and tapped it, so it can be opened again

Perhaps you can spray some WD40 in it, and see if it loosens up.

[cvf]

well, ok, mine is new. But there is maybe no guarantee that they are ok...