How do these door pads attach??

[green69rt]

This car was in pieces when I got it, so some things need to be figured out.  For example: Just doing some test fitting and tried the upper door pads in the back.   Then I noticed that there are only a couple of screw holes at the front and one at the back but nothing along the bottom (Pic #1).  Doesn't look like there is a place for anything anyway.  Looked on the back and I can see cutouts like there might be fasteners or clips or something (pic #2).  Is there supposed to be something there to attach to these tabs (pic #3)??

If I knew what to look for I would go thru my bins of left over parts.

[cdr]

door panel clips, one screw in the back into an oval plastic insert & one in the front edge.

[green69rt]

door panel clips, one screw in the back into an oval plastic insert & one in the front edge.

OK, dumb guy again!   These things seem to be what you mean.

PS check your PM.

[cdr]

yes

[Charger-Bodie]

The upper pad clips are wider where it goes into the back of the pad.

[SSmoothie]

I just took mine off I can take pics if you need some.

[green69rt]

I just took mine off I can take pics if you need some.

Yes, please, that might help me decide if I have the correct ones.

[SSmoothie]

Mine is a 68 Charger but they should be the same, notice the first clip is turned horizontal in the covers hole and the second 2 are vertically set. Hope this helps, plus thanks for all of your post I have saved a lot of them when I put mine back together.