Baffles in MP Cast Valve Covers

[70sixpkrt]

Should the screw in Baffles be under where my 3 nipple breather goes? Or should it be opened? I pulled off my covers to adjust the valves and noticed I don't have the baffle under the grommet hole. I have it under the hole that is not punched out.

[BLK 68 R/T]

Should be under the breather. It's not doing anything where it's at now.

[70sixpkrt]

I know the answer but just wanted to triple check. When I had my chrome Direct Connection Valve Covers, I had to cut out the baffles for clearance of the Rockers.

[BLK 68 R/T]

I have them on my motor. 440 source heads, Hughes 1.5 aluminum roller rockers. Baffles installed on the inside. No issues. If you do take them off or move them be sure to loc-tite the screws.

[Back N Black]

Should the screw in Baffles be under where my 3 nipple breather goes? Or should it be opened? I pulled off my covers to adjust the valves and noticed I don't have the baffle under the grommet hole. I have it under the hole that is not punched out.

Where does the three line from the breather connect?

[70sixpkrt]

Center carb, air cleaner, and vapor line.