*** what is exact measurement for hook for my rear bench seat ***

[Jas]

hello, I would like to know where is bolter the bottom seat of my back seat for my charge 69

thanks for pictures

[timmycharger]

Shouldn't be any bolts, the bottom part of the seat needs to be pushed firmly inwards and then up to get it out of the hooks underneath.  The top side of the seat gets pushed upward to get it off the package tray area and off of the tabs on each bottom corner. These tabs are visible near the front of the rear wheel wells I believe.

[birdsandbees]

 

[Jas]

ok my floor has been changed and I have no hooks

[Jas]

Is there someone who will have the measurement or is the hook for the back seat? I have them but I would have to install them on my floor


thanks

[Jas]

nobody can't help me?

i would like an exact measurement for not my seat moves by rolling ...

thank you

[xsr/tse]

I measured my unmolested 69 charger floor. and the drivers side hook measured 3.875" from the front edge of the hook to the front edge of where the floor drops off . and 4.00" on the passenger side. the hooks spacing from pass side to drivers side measured 43" center to center. and 9.5" passenger side and drivers side from the center of the hook to the lower rear door panel frame where the plastic rain shields tuck into the slot. I hope this helps?