69 charger driveshaft? HELP!!!!!

[jwells1993]

so im at the point now im lookin for a driveshaft for my big block swapped charger found just the driveshaft no yoke on ebay seller says it messures 52 inches i measured my rear end to tailshaft of tranny and got about 55 inches so would this driveshaft and a new slip yoke work? not sure how big the slip yoke would be thanks for any help im guessin itd work but just want some reassurance

[mopar0166]

Id have to say the yoke will be more then 3 " .  you don't want it to tight ether.  You need to measure carefully, Id suggest visiting stange's web site.  they have a measurement sheet that should help you.  if all else fails just order a new one from them.  It will be a better product then what was produced by dodge. 

Went through the same process my self 3 years ago, and I justified the cost by deciding I didn't want my drive shaft to be the weakest link.  I also added 1350 u-joints.

https://www.strangeengineering.net/forms/driveshaft-order-form/

good luck 

[jwells1993]

ok thank you