window jam

[Polygon]

Just as it sounds, I rolled the window up. Heard a 'small' noise. And now it's STUCK. can't move it a millimeter. So, I am getting the Factory Service Manual out...

I'm sure all the hardware is original.



window is stuck in the 'up' position.

Thanks

John

PS, it rolled up and down nicely, a while back, I lubed everything. Adjusted nice too. New window felts may have added to the drag.
----------------------------------

update, still hard to do, but using Yahoo Advanced search, I found quite a bit here, some going back 12 years.
http://www.dodgecharger.com/forum/index.php/topic,39415.0.html

http://www.dodgecharger.com/forum/index.php/topic,38431.0.html

http://www.dodgecharger.com/forum/index.php?topic=98556.0;all

http://www.dodgecharger.com/forum/index.php/topic,91429.0.html

[Polygon]

Looks like I will have to remove the whole vent window and door glass. Reading the posts, I can see this is going to be a bear. and quite frankly, for the first time I feel frustrated. So, according to the FSM,
#1, remove nut from stud on lower end of vent wing. Well, looks like mine was held there with a tie wrap.
#2,remove screw and washer assembly attaching vent wing to belt line. OK, stuck here. Where is this screw and washer?
#3, remove leg wing leg stud from slot in hinge pillar support. I am lost on that one too.

A step at a time here...

F points toward front.

loking under vent window.

and there is this screw on the bottom of the vent window. Do I remove that?

Thanks!!!

[70 sublime]

Did you try pulling the glass up and down or just turn the crank ?

I think I would try to find where it is stuck before pulling it all out of the door
As you have seen that is not very fun

[Polygon]

Glass is stuck too. HOWEVER, since the regulator is probably shot, I put vise grips and cranked on it HARD.  Broke it loose, and works good. Down the road, I will replace the regulator. Works ok now.

But will need fixing and replacing in the future.