"Charger" Sail Panel emblem

[MXZ69]

Hello, can anybody give me measurements/location on where to drill the holes for the "Charger" emblem that goes on the sail panel on a non-vinal top 69? Both passenger and driver side? My car had the holes filled in so I have no clue on where exactly to mount the emblem. Thank you.

[UFO]

I think it would be easier to locate the holes from the inside. This pic is the drivers side, with wire stuck thru the holes.

[keepat]

I used 1 inch graph paper and started from the edge of the quarter and against the aft most point of the rear side window. I hope this helps. These are the original holes for the Charger emblems with a vinyl top. Somebody can chime in, but I believe they are the same with or without a vinyl top.
Pat











Measurements for the driver side




P.m. me your address if you would like templates?

[MXZ69]

Thanks guys for pics! Really helped me out a lot. 

[richRTSE]

  wow, that was a really good idea!

[cdr]

this should be stickied with the trim holes.

[pipeliner]

I used 1 inch graph paper and started from the edge of the quarter and against the aft most point of the rear side window. I hope this helps. These are the original holes for the Charger emblems with a vinyl top. Somebody can chime in, but I believe they are the same with or without a vinyl top.
Pat











Measurements for the driver side




P.m. me your address if you would like templates?

I sent you a PM, could use a set for my NOS quarters. Thanks!!!

[crj1968]

Excellento pipeliner !