News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Rear Sheet Metal Layering

Started by sardillim, April 08, 2017, 06:31:40 PM

Previous topic - Next topic

sardillim

I am currently mocking up the rear sheet metal on my V10 Charger, If someone could post some pictures of the rear body panel and lower valance that would show how the panels are layered i would greatly appreciate it. 

Thank you

Mike

farm966

I could use this information as well. I tore my 1970 charger, was involved in a car accident and the project sat for several years before I have been able to get back onto it. After a nasty concussion and several years, I need a refresher on how the back of the car goes together.

Thanks.

sardillim

i can tell you that the way i have the 1/4 corners is correct,  but the rear valance should be on top of the 1/4 not behind it like in my pictures

farm966

Thanks. Any more info is appreciated. Good luck on your build, V-10? Nice!